Scope step site#
A test that can be used to step the motorized scope to a predefined scope site.
Description#
Steps the scope to the scope site with the given name as defined in SENTIO (e.g. MEASURE). If the scope site does not exist, an error occurs. The probe station must have a motorized scope.
Input parameters#
The test requires to select a probe station, added in the device manager.
| Parameter | Description |
|---|---|
| Scope site | Name of the scope site to step to. The value can be entered manually or selected using an existing Measmatic variable from a previous test. |
Output parameters#
The test does not provide output parameters.
Supported devices#
The following devices are supported by this test:
- MPI SENTIO Software Suite
Example#
Hardware setup:
Connect a supported Waferprober to the computer running Measmatic over TCP/IP, GPIB or RS232.
flowchart LR
A(Measmatic) o---o |TCP/IP,
GPIB or
RS232| B(Waferprober)In the device manager add the Waferprober to the current test site configuration. Change the name, the IP address in the device properties of the device. If needed, increase the communication timeout for the probe station device.
Measmatic setup:
- Define the scope site (e.g. MEASURE) in SENTIO.
- Add a Scope step site test to the test sequence and enter the name of the scope site.
- Execute the test sequence by pressing the Run all tests button.
See also: