Scope set home#
Sets the home position of the probe station scope.
Description#
The test sets the home position of the motorized scope of the connected probe station. Two modes are available:
| Mode | Meaning |
|---|---|
| Current position | The current scope position is stored as the new home position. |
| Position | The given x/y coordinates are stored as the new home position. |
Scope site positions and scope movements with the reference point "Home" are always relative to the scope home position.
Input parameters#
| Parameter | Description |
|---|---|
| Probe station | The probe station whose scope home position shall be set. |
| Home position | "Current position" or "Position" (see above). |
| Home x position | The home position on the x axis. (Only used in mode "Position".) |
| Home y position | The home position on the y axis. (Only used in mode "Position".) |
Output parameters#
This test does not store output parameters.
Supported devices#
All probe stations with a motorized scope, e.g. MPI SENTIO based probe stations
(SENTIO 3.0.2 or later, remote command set_scope_home).
Example#
Move the scope to the desired position, then run the test with mode "Current position" to store it as the new scope home position.